Синтаксис для разных пулов, разный. Из ридми файла клеймора:Jampwnz:fhntv_smart
vltk
Не хочет.
Кому то с дварфа приходят письма?
dwarfpool (and Stratum for Decred):
EthDcrMiner64.exe -epool eth-eu.dwarfpool.com:8008 -ewal 0xD69af2A796A737A103F12d2f0BCC563a13900E6F/YourWorkerName -epsw x -dpool stratum+tcp://dcr.suprnova.cc:3252 -dwal Redhex.my -dpsw x
Read dwarfpool FAQ for additional options, for example, you can setup email notifications if you specify your email as password.
И обратите внимание об отсутствии поддержки стратум на дворфе (у меня нанопул), первая строка faq из ридми:
- What is dwarfpool proxy (eth-proxy)?
Official Ethereum miner does not support Stratum protocol, it supports HTTP protocol only. It causes less profit because of delays.
A proxy was created to fix it, so official Ethereum miner is locally connected to the proxy by HTTP protocol, for local network delays due to HTTP protocol are small. Proxy is connected to the pool via Stratum protocol so it has small delays too. Currently most pools support Stratum and you have to use HTTP-to-Stratum proxy to make official miner work with pools properly. Of course you can try to connect official miner to a pool directly via HTTP but you will lose 10-20% shares because of a short block time in Ethereum.
This miner does not use HTTP protocol, it uses Stratum directly. So you should connect it directly to the pool at Stratum port and it will work a bit faster than official miner via proxy because there is no proxy between miner and pool.
Как выведу остальные, то ждите пампа и там 
и в какую сторону копать, может уже кто-то сталкивался ?
