После замены охлаждения на zalman vf 3000 ..появились артефакты ..Хозяин карты играл нормально около 30 минут ..перегрева не было .
потом появились артефакты такого рода




неужели сколол чип ?реально ли починить ?
БП seasonic на 550 ват, все и так на дефолте. Завтра куплю geforse gt610, и отпишусь.Inspiring:эта ошибка проблема материнок от MSI потому сразу и спросил
vadimenko
я бы начал с установки полностью всего на дефолт, а потом уже копать
БП какой ? Походу это просадки и нехватка питалова (это только догадка)
- спойлер
ok found this:
EDIT: OKAY, FOUND OUT THE CULPRIT of this Hypertransport Sync Flood Error.
Did some testing on the CPU, CPU-NB, HT and Ram.
The CPU was ONLY component that reproduced the HTSF Error.
When not enough volts are being provided to the CPU it will reboot at any time (Especially during heavy to max loads) with either a black screen or verticle lines right before rebooting. While posting you see this messege.
"hypertransport sync flood error has occured. Press F1 to resume"
So there are a number of Scenarios that may cause this BUT they ALL lead back to the main reason. Not enough power to the CPU at the time that the heavy load produces failure.
1. To high of an OC without the ample amount of CPU volts.
2. Plain, not enough CPU Volts at any speed.
3. Possible Bad power supply.
4. Motherboard with very high amount of VDroop which ultimately leads back to "Not Enough CPU Volts". This will reveal itself with a load on the CPU. Maybe not during typical use. Could just be that the motherboard has CPU power providing issues as well (Good power from PSU but motherboard wastes the power before reaching the CPU).
Hope that this helps someone out!
так там же полноразмерный х4 слотvadimenko:В нижний слот не влазит. Это что-то с материнкой?